Using Switches and LEDs on the XST-3.0 Board
USING SWITCHES AND LEDS ON THE XST-3.0 BOARD
This is a simple design example that takes two four-bit numbers entered through the DIP switch of the XST-3.0 Board and displays their sum or difference on the LED digits.
This is the VHDL file that describes the circuitry which accepts two four-bit numbers, adds or subtracts them and then displays the result on the LED digits.
These are the constraints which assign the I/O signals of the switches_leds module to the appropriate pins of the FPGA on the XSA-3S1000 + XST-3.0 combination.
This is a compiled bitstream for the design that can be downloaded into the XSA-3S1000 + XST-3.0 combination.
This is an alternate set of pin assignments to be used if the design is recompiled for an XSA-200 + XST-3.0 combination.
Open this project file with WebPACK if you need to recompile the design.
USING THE DESIGN EXAMPLE
- Step 1:
Set jumper J9 on the XSA-3S1000 Board to XS.
- Step 2:
Download the default parallel port interface into the XSA-3S1000 (
) if it is not already present. (Running GXSTEST will do this automatically.)
- Step 4:
Set the DIP switches to enter two four-bit numbers, (A3,A2,A1,A0) and (B3,B2,B1,B0), as follows:
1 2 3 4 5 6 7 8
| | | | | | | |
A3 A2 A1 A0 B3 B2 B1 B0
DIPSW1: A3 (most-significant bit of A)
DIPSW4: A0 (least-significant bit of A)
DIPSW5: B3 (most-significant bit of B)
DIPSW8: B0 (least-significant bit of B)
The sum of A and B will be displayed on LED1 and LED2.
Press pushbutton PB1 and the difference (A-B) will be displayed on LED1 and LED2.
This example design was developed using the following version of software:
Xilinx WebPACK : 6.3.03i
You can download the source files for this example design from the XESS website at /projects/xst3_switches_leds.zip .
Dave Vanden Bout, X Engineering Software Systems Corp.
Send bug reports to email@example.com.
COPYRIGHT AND LICENSE
Copyright 2006 by X Engineering Software Systems Corporation.
These applications can be freely distributed and modified as long as you do not remove the attributions to the author or his employer.
01/28/2006 - Initial release.