Using the RS232 Port on the XST-3.0 Board
USING THE RS232 PORT ON THE XST-3.0 BOARD
This is a simple design example that echoes characters received through the RS232 port of the XST-3.0 Board back to the sending terminal.
- miniuart.vhd, Rxunit.vhd, Txunit.vhd, utils.vhd
These are the design files for a UART that is used to send and receive eight-bit data through the DB9 connector on the XST-3.0 Board. Some small changes were made to these design files, but I can't quite remember what they were. The original files are stored in the
archive if you want to check.
This is the VHDL file that describes a simple state machine that accepts characters received by the UART module and then transmits them back through the UART to the terminal that sent them.
These are the constraints which assign the I/O signals of the RS232 module to the appropriate pins of the FPGA on the XSA-3S1000 + XST-3.0 combination.
This is a compiled bitstream for the design that can be downloaded into the XSA-3S1000 + XST-3.0 combination.
This is an alternate set of pin assignments to be used if the design is recompiled for an XSA-200 + XST-3.0 combination.
Open this project file with WebPACK if you need to recompile the design.
USING THE DESIGN EXAMPLE
- Step 1:
Set jumper J9 on the XSA-3S1000 Board to XS.
- Step 2:
Download the default parallel port interface into the XSA-3S1000 (
) if it is not already present. (Running GXSTEST will do this automatically.)
- Step 3:
Connect a straight-thru serial cable between the PC and the female DB9 connector of the XST-3.0 Board. On the XST-3.0 Board near the DB9 connector, make sure the shunts are arranged to connect the following pins on header J7: 1-3, 2-4, 5-7, 6-8.
- Step 4:
On the PC, open a Hyperterminal window with the following settings:
Bits per second: 9600
Data bits: 8
Stop bits: 1
Flow control: None
Download the RS232.bit
file to the XSA Board.
Start typing within the Hyperterminal window. The typed characters will be echoed back and displayed in the window.
This example design was developed using the following version of software:
Xilinx WebPACK : 6.3.03i
You can download the source files for this example design from the XESS website at /projects/xst3_RS232.zip .
Dave Vanden Bout, X Engineering Software Systems Corp.
Send bug reports to email@example.com.
COPYRIGHT AND LICENSE
Copyright 2006 by X Engineering Software Systems Corporation.
This application can be freely distributed and modified as long as you do not remove the attributions to the author or his employer.
01/28/2006 - Initial release.