Using the RS232 Port on the XST-3.0 Board

• USING THE RS232 PORT ON THE XST-3.0 BOARD
• DESIGN FILES
• USING THE DESIGN EXAMPLE
• ENVIRONMENT
• SOURCE FILES
• AUTHOR
• COPYRIGHT AND LICENSE
• HISTORY

---

---

USING THE RS232 PORT ON THE XST-3.0 BOARD

This is a simple design example that echoes characters received through the RS232 port of the XST-3.0 Board back to the sending terminal.

---

DESIGN FILES

• miniuart.vhd, Rxunit.vhd, Txunit.vhd, utils.vhd
  
These are the design files for a UART that is used to send and receive eight-bit data through the DB9 connector on the XST-3.0 Board. Some small changes were made to these design files, but I can't quite remember what they were. The original files are stored in the MiniUART.tar.gz archive if you want to check.
• RS232.vhd
  
This is the VHDL file that describes a simple state machine that accepts characters received by the UART module and then transmits them back through the UART to the terminal that sent them.
• RS232.ucf
  
These are the constraints which assign the I/O signals of the RS232 module to the appropriate pins of the FPGA on the XSA-3S1000 + XST-3.0 combination.
• RS232.bit
  
This is a compiled bitstream for the design that can be downloaded into the XSA-3S1000 + XST-3.0 combination.
• RS232-200.ucf
  
This is an alternate set of pin assignments to be used if the design is recompiled for an XSA-200 + XST-3.0 combination.
• RS232.npl
  
Open this project file with WebPACK if you need to recompile the design.

---

USING THE DESIGN EXAMPLE

• Step 1:
  
Set jumper J9 on the XSA-3S1000 Board to XS.
• Step 2:
  
Download the default parallel port interface into the XSA-3S1000 (\XSTOOLS\XSA\3S1000\dwnldpar.svf) if it is not already present. (Running GXSTEST will do this automatically.)
• Step 3:
  
Connect a straight-thru serial cable between the PC and the female DB9 connector of the XST-3.0 Board. On the XST-3.0 Board near the DB9 connector, make sure the shunts are arranged to connect the following pins on header J7: 1-3, 2-4, 5-7, 6-8.
• Step 4:
  
On the PC, open a Hyperterminal window with the following settings:

		Bits per second:  9600
		Data bits:           8
		Parity:           None
		Stop bits:           1
		Flow control:     None

• Step 5:
  
Download the RS232.bit file to the XSA Board.
• Step 6:
  
Start typing within the Hyperterminal window. The typed characters will be echoed back and displayed in the window.

---

ENVIRONMENT

This example design was developed using the following version of software:

	   Xilinx WebPACK       : 6.3.03i

---

SOURCE FILES

You can download the source files for this example design from the XESS website at /projects/xst3_RS232.zip .

---

AUTHOR

Dave Vanden Bout, X Engineering Software Systems Corp.

Send bug reports to bugs@xess.com.

---

COPYRIGHT AND LICENSE

Copyright 2006 by X Engineering Software Systems Corporation.

This application can be freely distributed and modified as long as you do not remove the attributions to the author or his employer.

---

HISTORY

01/28/2006 - Initial release.